- EVOlution Tanks
- Parts & Accessories
- Drip Tips
- Xtar Chargers
No Special products
Brown to Red Oak Bella/Elegance...
EVOlution Tank - Brown to Red Oak
Brown to Red Oak Bella/Elegance EVOlution Carto Tank. 100% Made in USA. One of a kind, no two exactly alike.
FREE one 10ml or two 5ml bottle(s) of Darkside Creations E-Juice of your choice. (Put in comment).
These tanks hold approximately 3.5 ml. They are designed to be both functional, as well as elegant, hence the name of this design, the "Elegance". Though we strive for perfection, there are no 2 exactly alike, due to their material nature. They are each true works of art. We hope you enjoy them as much as we enjoy providing them to the vaping community.
Tanks are warrantied against manufacturing defects only. The chances of these not being caught before shipping are very slim, due to the nature of our inspections and hand finishing. But in the rare case it happens, we'll be happy to exchange for another of like kind/color. If it is found to just be user error, the consumer will be responsible for shipping back to them. If you use a tank cracker liquids, we do offer spare tanks for sale :)
Your tank has come with only the need to install juice and the carto of your choice. The EVOlution Tank are made to fit standard 510 steel cartomizers. Tanks have been cleaned. Using a sharp punch is highly suggested,as this will not disfigure the cartomizer.
Step 1 - Have a pre punched cartomizer ready to install. Make sure the cartomizer is not deformed by the punching. The cartomizer must be round..
Step 2 - Remove the top cap. This should remove with very little effort! Never force the top cap off by prying with a knife or other device. The cap should release with slight pulling/twisting motion.
Step 3 - Prefill your cartomizer with liquid. Lubricate all o rings with VG, PG, or your liquid. Lubricate the outside metal case of your cartomizer. Leave the little white cap on the cartomizer, or use a carto tool or drip tip that is no wider than the cartomizer. Push the cartomizer up into the tank, from the bottom going up, careful not to damage the o ring. The drip tip or carto protects the o rings from being cut by the sharp edges of the cartomizer edge. The most important thing is to lube the outer part of the cartomizer before trying to install. Line up the bottom of the cartomizer with the bottom of the lower cap. It does not have to go all the way up into the top cap! Air flow area is needed.
Step 4 - Fill your tank with liquid, about 2ml, leaving enough space for the top cap, about 1/4".
Step 5 - Take the top cap and lube the o ring. This is critical! Slide the hole in the top cap over the cartomizer, just to the o ring, so you have a very loose seal. Now tilt the tank so the air bubble is over one of the holes in the cartomizer. Push the top cap all the way on now. With the juice as lubrication, this should click right in without too much effort.
Always lube o rings! O rings will swell a bit, so don't panic if you think the fit is too loose. It will tighten up as liquid absorbs into the o rings. This takes only a few minutes.
Instructions for removing any acrylic smell or taste from a tank